Product List
     
  
Home > News
Common faults and handling methods for rotary packing machine
With the rapid development of automation and intelligent technology, the rotary packing machine equipment is more and more common. This type of packaging machine consists of two parts: the measuring machine and the bag-type vacuum packaging machine. The equipment completes its work flow through mechanization and intelligence, and can realize the unmanned workshop management, which has attracted more and more attention and favor from the masses in the industry.


Although the advantages of the fully rotary packing machine are relatively prominent at present, its reasonable operation can bring many benefits to the enterprise. However, in the actual operation process, the equipment often has some failures after many users respond. For this reason, HuaLian Machinery will summarize the related issues. The specific instructions are as 


rotary packing machine

rotary packing machine


follows:

Common failure modes related to this device:

1) When the equipment is working, the film material is easily offset and cannot be fed normally. How should we adjust this situation? A manufacturer's technicians said that if the film material is offset in the equipment and the position of the film roll and the tension balance bar are invalid, the angle of the upper triangle plate can be adjusted to solve the problem. In addition, if the upper film material is offset from the material chain, the upper triangular plate can be adjusted clockwise; the lower film material is offset from the clamping chain, and the upper triangular plate can be adjusted counterclockwise.

2) The shrinking machine heats up slowly or cannot rise to a higher temperature. What is the reason for this situation? It is reported that the heater line is the main power line through a magnetic switch to the electric heating tube, so if the shrinking machine heats up slowly or can not rise to a higher temperature, it should first check whether the contacts of the magnetic switch are normal. In general, if the line does not pass one of the phases, the above phenomenon will occur; if the magnetic switch is normal, you can check the meter again to see if the phase and the ohmic value of the machine are the same; if each phase is connected but the line or electric heat If the tube is still abnormal, the heater needs to be replaced.


3) The vacuum of the packaged product is low. The vacuum degree of the product mainly depends on the vacuum pump. When such problems occur, the user should check whether the vacuum pump oil is contaminated. If it is contaminated, the vacuum pump oil needs to be replaced.

4) The seal is not flat or not sealed. The cause of the failure is related to whether the heating time is adjusted and whether there is any impurity on the heating cloth. The user needs to adjust the heating time and heating temperature. If there is any attachment on the heating cloth, it should be cleaned and replaced in time to prevent normal work.

It is reported that customers can also add details such as door opening and emergency stop, automatic card shooting, and abnormal discharge according to packaging requirements. The whole process of packaging does not require manual work, which effectively improves production efficiency and saves labor and management costs for the enterprise. The cost.

In addition, the rotary packing machine can also realize multi-purpose use of one machine, and the user can realize automatic packaging of particles, powder, block, liquid, and the like only by different metering devices according to different materials.