Product List
     
  
Home > News
Eight steps of blister packaging machine operation
Eight steps of blister packaging machine operation

1. Prepare medicines and packaging materials, replace the batch number template, install PVC and aluminum foil, check the cooling water, and clean the equipment carefully;
2. Turn on the power supply to send compressed air;
3. Press the heating key, and adjust the heating and heat sealing temperature control tables to the appropriate temperature respectively;
4. Pull the PVC hard film under the punching knife through the channel, and pull the aluminum foil under the heat sealing plate;
Fifth, when the heating plate and heat sealing plate are raised to the appropriate temperature, adjust the cooling temperature table to the appropriate temperature (generally 30C);
6. When the medicine is full of the blanking track, press the green button of the motor to run the empty car. After the blowing, heat sealing and punching have reached the requirements, connect the tablet hopper vibration button and the planetary cloth switch
7. When adjusting the blanking, make the blanking meet the requirements and carry out normal packaging;
8. After the packaging is completed, shut down in the following order: press the pill bucket shut-down button, press the motor red button, the host stops and shuts off, turn off the main power switch, close the intake valve, and close the inlet valve. "Then clean the machine and the site, and raise the packaging equipment.