The forming mechanism of the blister packaging machine is divided into: forming plate, forming cooling plate, blowing plate, pad, blowing cooling plate, stacking reed, and four black adjusting rods.
      Principle and adjustment method: The forming plate is fastened to the movable seat of the forming plate mechanism by its cooling plate, and the positioning pin is used for positioning between the two. Cooling plate fixing screws 2 M8 diagonal installation, molding plate fixing screws 2 M6 parallel installation, loosening the above screws, so that the outer end surface of the forming plate is guaranteed to be opposite to the outer end surface of the movable seat. Tighten the screws and use the hand-cranked car to move the movable seat downwards, so that the gap stops when it reaches about 3mm. Loosen the two M8 and two M6 screws and fully align the three end faces of the forming plate and the blowing plate with your hand and hold it. Continue to drive the car so that the blow plate and the forming plate are completely closed and pressed, stop the car, tighten the above four screws, and the initial adjustment is completed.
      Confirm the adjustment method: Run the equipment to form the blister, and measure the outer end of the bubble shape with a 300mm steel ruler. Parallel means that the forming mechanism is qualified. If it is not parallel, it is necessary to separately rotate the left and right positions of the forming plate until the outer end faces of the formed blister are parallel (the guiding plate should not be completely tightened, and then fastened after alignment).

Flat blister packaging machine https://www.hlyj.net/Products/71/ recommended: