1 There is a positioning pin positioning connection between the lower mesh plate and the lower mesh plate cooling plate, and the cooling plate has two M8 screws fixed to the movable seat. Loosen the M8 screw to make the lower anilox plate parallel to the outer end surface of the movable seat. The distance between the mesh cooling plate and the outer end surface of the movable seat is about 5 mm. At this time, loosen the six M6 screws fastened on the large platform, and use the steel ruler to align the platform guide with the outer end surface of the lower anilox plate, and fasten the above six M6 screws.
2 After adjusting the above items, the disk moving device moves the movable seat upwards, and stops when the spacing between the mesh plate and the net pattern plate is about 3 mm. Loosen the two M6 screws that fasten the heating body, place them on the lower mesh plate, align the two outer end faces of the lower mesh plate and the net pattern plate, hold on to continue the car, wait for the fully closed compression and fasten. Better than 2 screws.