Composition and principle of punching mechanism of blister packaging machine
The composition of the punching mechanism of the blister packaging machine
: punch and die, pre-pressing plate, reset pressure spring.
The principle and adjustment method of the punching mechanism of the blister packaging machine
: the three screws of the die are installed first but not completely fastened, and the punching seat is tilted several times. It is felt that the notch of the punch seat and the coupling column are completely aligned with each other. For the punch holder, tighten the M10 screw of the coupling post. Then, the outer end surface of the die holder is adjusted to be about 16 mm away from the outer end surface of the punching movable seat, and three M6 screws are fastened after the size is ensured.
Adjust the qualified inspection method: After the installation is completed, the punching synchronous toothed belt should be released to the back of the equipment, and the synchronous gear wheel - week can be rotated by hand to ensure smooth and no stuck rotation.
Pay more attention to aluminum-plastic packaging machine products and information: https://www.hlyj.net/Products/71/